Toyota Sienna Service Manual: Power slide door control switch
INSPECTION
1. INSPECT POWER SLIDE DOOR CONTROL SWITCH
- Inspect the resistance of the switch for LH / RH.
Resistance
If the result is not as specified, replace the switch.
- Apply battery voltage and check the illuminates.
Standard
If the result is not as specified, replace the bulb.
HINT: Whether the switch illuminates or not will not affect the function of the LH side.
Power slide door main switch
INSPECTION
1. INSPECT POWER SLIDE DOOR MAIN SWITCH
Inspect the resistance of the switch.
Resistance
If the result is not as specified, replace the switch.
Apply battery voltage and ...
Power slide door touch sensor
INSPECTION
1. INSPECT POWER SLIDE DOOR TOUCH SENSOR LH
Check the resistance of the sensor.
Resistance
If the result is not as specified, replace the sensor.
2. INSPECT POWER SLIDE DOOR ...
Other materials:
Installation
1. INSTALL HEATED OXYGEN SENSOR (for Bank 2
Sensor 2)
(a) Using SST, install the heated oxygen sensor to the
front exhaust pipe.
SST 09224-00010
Torque: 40 N*m (408 kgf*cm, 30 ft.*lbf) for use
with SST
44 N*m (449 kgf*cm, 32 ft.*lbf) for use
without SST
HINT:
Use a torque wrench wit ...
If a warning light turns on
or a warning buzzer
sounds
Calmly perform the following actions if any of the warning lights
comes on or flashes. If a light comes on or flashes, but then
goes off, this does not necessarily indicate a malfunction in the
system. However, if this continues to occur, have the vehicle
inspected by your Toyota dealer.
Warnin ...
Rear Blower Motor Circuit
DESCRIPTION
Power to the rear blower motor is supplied from the battery via the RR A/C
relay.
The rear blower motor speed level varies between 0 and 31 based on the voltage
difference measured
between the terminals of the motor.
The voltage difference measured between the terminals of th ...
