Toyota Sienna Service Manual: Rear differential side gear shaft bolt

Reassembly

1. INSTALL REAR DIFFERENTIAL PINION SHAFT (a) Install the 2 thrust washers to the 2 side gears. (b) Install the 2 side gears, 2 differential pinion gears, 2 differential pinion thrust washers ...

Removal

1. REMOVE REAR WHEEL 2. REMOVE EXHAUST PIPE ASSEMBLY HINT: Perform this procedure only when removing the RH side. (See page EX-8) 3. REMOVE REAR SPEED SENSOR LH HINT: (See page DS-21) 4. REM ...

Other materials:

Reassembly
1. INSTALL GENERATOR ROTOR ASSEMBLY (a) Place the drive end frame on the clutch pulley. (b) Install the generator rotor assembly to the drive end frame. (c) Place a new generator washer on the generator rotor. 2. INSTALL GENERATOR COIL ASSEMBLY (a) Using a deep socket wrench (21 ...

Register transmitter id (using intelligent tester)
(a) Connect the intelligent tester to DLC3 (Procedure "A"). (b) Turn the ignition switch to the ON position (Procedure "B"). (c) Select the REGIST TIRE following the intelligent tester screen (UTILITY - REGIST TIRE) (Procedure "C"). (d) Input the IDs (ID1 t ...

Removal
1. BOLT, SCREW AND NUT TABLE  The bolts, the screws and the nuts, which are necessary for installation and removal of the instrument panel are shown in the illustration below with alphabets. 2. DISCONNECT BATTERY NEGATIVE TERMINAL 3. REMOVE STEERING WHEEL COVER LOWER NO.2 4. ...