Toyota Sienna Service Manual: Rear door courtesy switch
INSPECTION
1. FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY
- Check that there is resistance between the terminal and the switch body when the switch is operated.
Resistance:
ON (When shaft is pressed):
10 kΩ or higher
OFF (When shaft is not pressed):
Below 1 Ω
Front door courtesy switch
INSPECTION
1. FRONT DOOR COURTESY LIGHT SWITCH
ASSEMBLY
Check that there is resistance between the terminal
and the switch body when the switch is operated.
Resistance:
ON (When shaf ...
Back door courtesy switch
INSPECTION
1. BACK DOOR LOCK ASSEMBLY (WITH OUT POWER BACK DOOR)
Inspect back door courtesy light switch operation.
Check that there is resistance between the
terminal 5 a ...
Other materials:
Vehicle Speed Signal Circuit between Radio and Navigation Assembly
and Combination Meter
DESCRIPTION
The radio and navigation assembly receives a vehicle speed signal from the
combination meter and
information about the GPS antenna, and then adjusts vehicle position.
HINT:
A voltage of 12 V or 5 V is output from each ECU and then input to
the combination meter. The sig ...
Inspection
1. INSPECT PACK CLEARANCE OF FORWARD CLUTCH
(a) Install the forward clutch on the oil pump.
NOTICE:
Be careful not to damage the oil seal ring of oil
pump.
b) Using a dial indicator, measure the forward clutch
pack clearance while applying and releasing
compressed air (392 kPa, 4.0 kgf/cm ...
Disassembly
1. REMOVE RETURN TUBE NO.2
(a) Using SST, remove the return tube No. 2.
SST 09023-12701
2. REMOVE STEERING LEFT TURN PRESSURE TUBE
(a) Using SST, remove the left turn pressure tube.
SST 09023-38201
(b) Remove the 2 O-rings from the left turn pressure
tube.
3. REMOVE STEERING RIGH ...
