Toyota Sienna Service Manual: Front door courtesy switch
INSPECTION
1. FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY
- Check that there is resistance between the terminal and the switch body when the switch is operated.
Resistance:
ON (When shaft is pressed):
10 kΩ or higher
OFF (When shaft is not pressed):
Below 1 Ω
Stop light switch
ON-VEHICLE INSPECTION
1. STOP LIGHT SWITCH ASSEMBLY
Check the resistance between the terminals at each
switch position as shown ion the chart.
Resistance
...
Rear door courtesy switch
INSPECTION
1. FRONT DOOR COURTESY LIGHT SWITCH
ASSEMBLY
Check that there is resistance between the terminal
and the switch body when the switch is operated.
Resistance:
ON (When shaf ...
Other materials:
Disassembly
1. INSPECT OIL PUMP ASSEMBLY
HINT:
(See page AX-234)
2. REMOVE CLUTCH DRUM OIL SEAL RING
(a) Remove the 2 clutch drum oil seal rings.
3. REMOVE STATOR SHAFT ASSEMBLY
(a) Using a "torx" socket (T30), remove the 11 bolts and
stator shaft.
4. INSPECT CLEARANCE OF OIL PUMP ASSEMBLY ...
Short in Front Pretensioner Squib RH Circuit
DTC B0130/63 Short in Front Pretensioner Squib RH Circuit
DESCRIPTION
The front pretensioner squib RH circuit consists of the center airbag sensor
assembly and the front seat
outer belt assembly RH.
This circuit instructs the SRS to deploy when deployment conditions are met.
DTC B0130/63 ...
Check that initialization has been completed
(a) Confirm that the data of tire pressure of all tires are
displayed on the intelligent tester screen.
Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
TIREPRESS1
ID1 tire inflation pressure (Absolute
pressure) /
min.: 100 kPa (1 kgf/cm2, 14 ...
