Toyota Sienna Service Manual: Removal
1. REMOVE NO. 1 REAR SEAT OUTER BELT ASSEMBLY (for 8-Passenger)
HINT: Refer to the instructions for disassembly of the rear No .1 seat assembly (for center seat).
- Remove the rear seatback board.
- Remove the rear seat shoulder belt cover.
- Remove the 2 bolts, 2 nuts and No. 1 rear seat outer belt assembly.
2. REMOVE 3 POINT TYPE NO. 2 REAR SEAT BELT ASSEMBLY
- Remove the roof headlining.
HINT: Refer to the instructions for removal of the roof headlining.
- Remove the 2 bolts, 2 nuts and 3 point type No. 2 rear seat belt assembly.
Rear center seat outer belt assembly
COMPONENTS
...
Installation
1. INSTALL 3 POINT TYPE NO. 2 REAR SEAT BELT ASSEMBLY
Check the degree of tilt when the belt begins to lock
the ELR.
Check that the belt does not lock within 15 of
tilt i ...
Other materials:
DSP Error/ DSP Error
DTC 62-78 DSP Error
DTC 63-78 DSP Error
DESCRIPTION
INSPECTION PROCEDURE
HINT:
After the inspection is completed, clear the DTCs.
NOTICE:
These codes may be output even if there is no malfunction.
If these codes are output frequently, replace the radio receiver.
1 CLEA ...
Monitor result information
If you use a generic scan tool, multiply the test value by
the scaling value listed below.
...
Removal
1. REMOVE V-BANK COVER SUB-ASSEMBLY (See
page EM-28)
2. DISCONNECT VENTILATION HOSE
(a) Disconnect the ventilation hose from the ventilation
valve.
3. REMOVE VENTILATION VALVE
(a) Remove the ventilation valve. ...
