Toyota Sienna Service Manual: Room light assembly
ON-VEHICLE INSPECTION
1. ROOM LIGHT ASSEMBLY NO.2
- Check that the resistance exists between the terminals.
Resistance: Below 1 Ω
2. INTERIOR DOME LIGHT SWITCH ASSEMBLY
- Check that there is resistance between the terminals at each switch position as shown in the chart.
Resistance
- Inspect illumination operation.
- Connect the battery positive (+) lead to the terminal 4 and the battery negative (-) lead to the terminal 1, and check that the illumination comes on.
Personal light assembly
ON-VEHICLE INSPECTION
1. ROOF CONSOLE BOX ASSEMBLY
Inspect map light assembly resistance.
Check the resistance between the terminals at
each switch position as shown in th ...
Door courtesy light (for Rear
Side)
ON-VEHICLE INSPECTION
1. REAR DOOR COURTESY LIGHT ASSEMBLY LH
Check that the exists between the terminals.
Resistance:
Below 1 Ω
2. REAR DOOR COURTESY LIGHT ASSEMBLY RH
...
Other materials:
PBD Pulse Sensor Malfunction
DTC B2222 PBD Pulse Sensor Malfunction
DESCRIPTION
A pulse sensor is built into the back door for a jam and foreign
object detection and for back door
position detection. The jam and foreign object detection feature of the
pulse sensor monitors the
operating speed of the back door whi ...
Reassembly
1. INSTALL COOLER DRYER
(a) Using needle nose pliers, install the cooler dryer.
(b) Install a new O-ring on the cap.
(c) Sufficiently apply compressor oil to the fitting
surfaces of the O-ring and the cap.
Compressor oil:
ND-OIL 8 or equivalent
(d) Using a hexagon wrench 14 mm ( ...
Air Inlet Damper Position Sensor Circuit
DESCRIPTION
This sensor detects the position of the air inlet control servo motor and
sends the appropriate signals to
the A/C amplifier. The position sensor is built in the air inlet control servo
motor.
The position sensor's resistance changes as the air inlet control servo motor
ar ...
