Toyota Sienna Service Manual: Door courtesy light (for Rear Side)
ON-VEHICLE INSPECTION
1. REAR DOOR COURTESY LIGHT ASSEMBLY LH
- Check that the exists between the terminals.
Resistance: Below 1 Ω
2. REAR DOOR COURTESY LIGHT ASSEMBLY RH
- Check that the exists between the terminals.
Resistance: Below 1 Ω
Room light assembly
ON-VEHICLE INSPECTION
1. ROOM LIGHT ASSEMBLY NO.2
Check that the resistance exists between the
terminals.
Resistance:
Below 1 Ω
2. INTERIOR DOME LIGHT SWITCH ASSEMBLY
...
Ignition key cylinder light
ON-VEHICLE INSPECTION
1. KEY CYLINDER LIGHT ASSEMBLY
Connect the battery positive (+) lead to the terminal
1 and the battery negative (-) lead to the terminal 2,
and check that the ...
Other materials:
Installation
1. INSTALL PARKING BRAKE CABLE ASSEMBLY NO.3
(a) Install the parking brake cable LH guide to the
parking brake cable assembly No. 3.
(b) Connect the parking brake cable No. 3 to the
parking brake cable equalizer.
(c) Install the parking brake cable No. 3 with the 3 bolts
and button.
T ...
Battery
Check the battery as follows:
Battery exterior
Make sure that the battery terminals are not corroded and that
there are no loose connections, cracks, or loose clamps.
Terminals
Hold-down clamp
Before recharging
When recharging, the battery produces hydrogen gas which is flammable an ...
ECM / PCM Internal Engine Off Timer Performance
DTC P2610 ECM / PCM Internal Engine Off Timer Performance
DTC SUMMARY
DESCRIPTION
To ensure the accuracy of the EVAP (Evaporative Emission) monitor values, the
soak timer, which is built
into the ECM, measures 5 hours (+/- 15 minutes) from when the ignition switch is
turned off, before t ...
