Toyota Sienna Service Manual: Pressing Power Switch does not Turn on System
INSPECTION PROCEDURE
1 CHECK VEHICLE CONDITION
- Check that conditions in the cabin are not likely to cause condensation.
HINT: This problem occurs when the cabin is humid and the temperature changes rapidly. This may produce condensation, resulting in a short circuit.
OK: Condensation is not likely to be produced.
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
Noise Occurs
INSPECTION PROCEDURE
1 NOISE CONDITION
Check in which direction the noise comes from (front left
or right, or rear left or right).
Check in which direction the noise comes from.
OK:
T ...
No Sound can be Heard from Speakers
INSPECTION PROCEDURE
1 CHECK RADIO RECEIVER
Check radio receiver setting.
Check that the volume is not set to "0".
Check that "MUTE" is off.
OK:
The vo ...
Other materials:
Removal
1. PRECAUTION
CAUTION:
Be sure to read "PRECAUTION" thoroughly before
servicing.
2. DISCONNECT CABLE FROM NEGATIVE BATTERY
TERMINAL
CAUTION:
Wait for 90 seconds after disconnecting the cable to
prevent the airbag working.
3. PLACE FRONT WHEELS FACING STRAIGHT AHEAD
4. REMOVE STEE ...
Removal
1. REMOVE FRONT EXHAUST PIPE ASSEMBLY
HINT:
(See page EX-8)
2. REMOVE PROPELLER WITH CENTER BEARING
SHAFT ASSEMBLY
HINT:
(See page PR-3)
3. REMOVE REAR DIFFERENTIAL FILLER PLUG
(a) Using a hexagon wrench (10 mm), remove the filler
plug and gasket.
4. REMOVE REAR DIFFERENTIAL DRAIN PLUG
(a ...
Magnetic clutch relay
ON-VEHICLE INSPECTION
1. INSPECT MAGNETIC CLUTCH RELAY
(a) Remove the magnetic clutch relay.
(b) Measure the resistance according to the value(s) in
the table below.
Standard resistance
If the resistance is not as specified, replace the
magnetic clutch relay. ...
