Toyota Sienna Service Manual: Seat position sensor

Installation

HINT:  Use the same procedures for the RH side and LH side.  The procedures listed below are for the LH side. 1. INSTALL REAR AIRBAG SENSOR LH  Check that the ignition ...

On-vehicle inspection

1. INSPECT SEAT POSITION SENSOR (VEHICLE NOT INVOLVED IN COLLISION)  Perform a diagnostic system check. 2. INSPECT SEAT POSITION SENSOR (VEHICLE INVOLVED IN COLLISION)  Perform ...

Other materials:

Installation
1. INSTALL REAR SEAT 3 POINT TYPE BELT ASSEMBLY (for 8-Passenger) HINT: Refer to the instructions for reassembly of the rear No. 1 seat assembly (for center seat).  Install the rear seat 3 point type belt assembly with the bolt. Torque: 42 N*m (430 kgf*cm, 31 ft.*lbf) 2. INSTALL ...

Problem symptoms table
HINT:  Use the table below to help determine the cause of the problem symptom. The likely causes of the problem are indicated in descending order. Check each suspected area in order. Repair or replace faulty parts or perform adjustments as necessary.  Inspect the fuse and rel ...

Rear wheel alignment
ADJUSTMENT NOTICE: For vehicles equipped with VSC, if wheel alignment has been adjusted, and if suspension or underbody components have been removed/installed or replaced, be sure to perform the following initialization procedure in order for the system to function normally: 1. Disconnect the ...