Toyota Sienna 2010-2026 Owners Manual: Setting the vehicle speed (vehicle-to-vehicle distance control mode)
- Press the “ON-OFF” button to
activate the cruise control.
Dynamic radar cruise control indicator will be displayed.
Press the button again to deactivate the cruise control.
- Accelerate or decelerate the
vehicle to the desired speed,
and push the lever down to set
the speed.
“SET” indicator will be displayed.
The vehicle speed at the moment the lever is released becomes the set speed.
Summary of functions
Dynamic radar cruise control supplements conventional cruise control
with a vehicle-to-vehicle distance control. In vehicle-to-vehicle distance
control mode, the vehicle automatically accelerates or ...
Adjusting the set speed
To change the set speed, operate the lever until the desired set speed
is displayed.
Increases the speed
Decreases the speed
Fine adjustment: Momentarily
move the lever in the desired d ...
Other materials:
Short to GND in Driver Side Squib 2nd Step Circuit
DTC B1182/19 Short to GND in Driver Side Squib 2nd Step Circuit
DESCRIPTION
The driver side squib 2nd step circuit consists of the center airbag sensor
assembly, the spiral cable and
the steering pad.
The circuit instructs the SRS to deploy when deployment conditions are met.
DTC B1182/19 ...
Speedometer Malfunction
DESCRIPTION
Factors that affect the indicated vehicle speed include tire size, tire
inflation, and tire wear. The speed indicated on the speedometer has an
allowable margin of error. This can be tested using a speedometer tester
(calibrated chassis dynamometer). For details about testing and ...
Drive shaft system
PRECAUTION
1. NOTICE OF REMOVING AND INSTALLING FRONT
DRIVE SHAFT ASSEMBLY RH
(a) When removing and installing the front drive shaft
assembly RH in a 4WD vehicle, be sure to first drain
all the transaxle oil and transfer oil. If removal and
installation is carried out without draining these oi ...
