Toyota Sienna 2010-2026 Owners Manual: Using the driving support systems

Closing the fuel tank cap

After refueling, turn the fuel tank cap until you hear a click. Once the cap is released, it will turn slightly in the opposite direction. WARNINGWhen replacing the fuel tank cap Do ...

Cruise control

...

Other materials:

Installation
1. INSTALL FRONT SEAT ASSEMBLY LH  Place the seat assembly in the cabin. NOTICE: Be careful not to damage the body.  Connect the connectors under the seat assembly.  Tighten the 2 bolts on the front side of the seat assembly. Torque: 37 N*m (375 kgf*cm, 27 ft.*lb ...

Sensor signal check by test mode (signal check) (when using intelligent tester)
(a) When having replaced the skid control ECU and/or yaw rate and deceleration sensor, perform zero point calibration of the yaw rate and deceleration sensor. HINT: If the ignition switch is turned from the ON position to the ACC or off during test mode (signal check), DTCs of the signal ...

Inspection
1. Inspect no. 3 Intake air control valve assembly (A) inspect actuator operation. (1) With 26.7 Kpa (200 mm hg, 7.9 In. Hg) of vacuum applied to the actuator, check that the actuator rod moves. (2) One minute after applying the vacuum, check that the actuator rod does not return. ...