Toyota Sienna Service Manual: Spiral cable

Disposal

HINT: When scrapping a vehicle equipped with the SRS or disposing of the steering pad, be sure to deploy the airbag first in accordance with the procedure described below. If any abnormality occur ...

Removal

1. PRECAUTION CAUTION: Be sure to read "PRECAUTION" thoroughly before servicing. 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL CAUTION: Wait for 90 seconds after disconnecting th ...

Other materials:

Positioning a floor jack
When using a floor jack, follow the instructions in the manual provided with the jack and perform the operation safely. When raising your vehicle with a floor jack, position the jack correctly. Improper placement may damage your vehicle or cause injury. Front Rear 2WD ...

High beam automatic turning on or off conditions
When all of the following conditions are fulfilled, high beam will be automatically turned on (after approximately 1 second): Vehicle speed is above approximately 20 mph (32 km/h). The area ahead of the vehicle is dark. There are no oncoming or preceding vehicles with headlights or tail ...

Camshaft Position "B" Actuator Circuit / Open
DTC P0013 Camshaft Position "B" Actuator Circuit / Open (Bank 1) DTC P0023 Camshaft Position "B" Actuator Circuit / Open (Bank 2) DESCRIPTION The Variable Valve Timing (VVT) system includes the ECM, OCV and VVT controller. The ECM sends a target duty-cycle control signal ...