Toyota Sienna Service Manual: Starting system
Parts location
System diagram
The starting system rotates the starter motor according to the signals from the ignition switch and pnp switch.
2Gr-fe starting
...
Starter
Components
...
Other materials:
On-vehicle inspection
1. CHECK ACCELERATOR PEDAL ROD
Check the voltage.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to the ON position.
Turn the intelligent tester on.
Select the menu items: DIAGNOSIS /
ENHANCED OBD II / DATA LIST / ALL /
ACCEL POS ...
Turbine Speed Sensor Circuit No Signal
DESCRIPTION
This sensor detects the rotation speed of the input turbine. By comparing the
input turbine speed signal
(NT) with the counter gear speed sensor signal (NC), the ECM detects the shift
timing of the gears and
appropriately controls the engine torque and hydraulic pressure accor ...
Power back door drive unit
INSPECTION
1. INSPECT POWER BACK DOOR DRIVE UNIT
Remove the unit.
Apply battery voltage to the terminals and check the
motor operation.
Standard
If the result is not as specified, replace the drive
unit.
Check the resistance of the clutch terminals.
Resistance
If th ...
