Toyota Sienna Service Manual: Starter

Starting system

Parts location System diagram The starting system rotates the starter motor according to the signals from the ignition switch and pnp switch. ...

Removal

1. REMOVE BATTERY (See page EM-26) 2. REMOVE NO. 2 AIR CLEANER INLET (See page EM- 28) 3. REMOVE AIR CLEANER CAP SUB-ASSEMBLY (See page FU-13) 4. REMOVE AIR CLEANER FILTER ELEMENT (See page EM-2 ...

Other materials:

Brake Switch
DESCRIPTION The stop light switch is a duplex system that transmits two signals: STP and ST1-. These two signals are used by the ECM to monitor whether or not the brake system is working properly. If the signals, which indicate the brake pedal is being depressed or released, are detected ...

Drive belt
COMPONENTS REMOVAL 1. REMOVE FRONT WHEEL RH 2. REMOVE FRONT FENDER APRON SEAL RH (See page EM-26) 3. REMOVE V-RIBBED BELT (a) Using SST, release the belt tension by turning the belt tensioner counterclockwise, and remove the Vribbed belt from the belt tensioner. SST 09249-63010 (b) ...

Diagnostic trouble code chart
If a trouble code is displayed during the DTCs check (sensor check), check the circuit listed for the code in the table below (Proceed to the page given for that circuit). AIR CONDITIONING SYSTEM HINT: *1: If the cabin temperature is approximately -18.6°C (- 3.7°F) or lo ...