Toyota Sienna Service Manual: Engine
- 2Gr-fe engine control system
- Sfi system
- Crankshaft position sensor
- Engine coolant temperature sensor
- Knock sensor
- Efi relay
- Circuit opening relay
- Air fuel ratio sensor relay
- Engine
- Drive belt
- Engine front oil seal
- Engine rear oil seal
- Engine assembly
- Engine unit
- 2Gr-fe fuel
- 2Gr-fe emission control
- Emission control system
- Canister
- Vacuum switching valve
- Ventilation valve
- Air fuel ratio sensor (for 2wd)
- Air fuel ratio sensor (for 4wd)
- Heated oxygen sensor (for 2wd)
- Inspection
- Heated oxygen sensor (for 4wd)
- Fuel tank cap
- 2Gr-fe intake
- 2Gr-fe exhaust
- 2Gr-fe cooling
- Cooling system
- Cooling fan system
- Coolant
- Water pump
- Thermostat
- Cooling fan motor
- Cooling fan ecu
- Cooling fan relay
- Radiator
- 2Gr-fe lubrication
- 2Gr-fe starting
- 2Gr-fe charging
- 2Gr-fe ignition
Installation
1. INSTALL ENGINE OIL COOLER
(a) Clean the oil cooler contact surface on the cooler
mounting.
(b) Install a new O-ring to the oil cooler.
(c) Install the oil cooler assembly with the uni ...
Ignition system
Parts location
System diagram
...
Other materials:
Battery
Check the battery as follows:
Battery exterior
Make sure that the battery terminals are not corroded and that
there are no loose connections, cracks, or loose clamps.
Terminals
Hold-down clamp
Before recharging
When recharging, the battery produces hydrogen gas which is flammable an ...
Removal
1. DISCONNECT CABLE FROM NEGATIVE BATTERY
TERMINAL
2. REMOVE FRONT BUMPER ASSEMBLY
Remove the 4 screws and separate the fender liner
from the front bumper assembly.
Remove the 8 screws and separate the engine
under cover from the front bumper assembly.
Remove the 5 ...
License plate light assembly
COMPONENTS
REMOVAL
1. REMOVE BACK DOOR GARNISH CENTER
2. REMOVE BACK DOOR SIDE GARNISH LH
3. REMOVE BACK DOOR SIDE GARNISH RH
4. REMOVE BACK DOOR STRAP COVER
5. REMOVE BACK DOOR PULL STRAP
6. REMOVE BACK DOOR TRIM BOARD ASSEMBLY
7. REMOVE BACK DOOR GARNISH SUB-ASSEMBLY OUTSIDE
8. RE ...
