Toyota Sienna Service Manual: Tire and wheel system

Toyota Sienna Service Manual / Tire and wheel / Tire and wheel system

Precaution

1. REMOVAL AND INSTALLATION TIRE PRESSURE WARNING VALVE AND TRANSMITTER (a) When installing a tire, make sure that the tire pressure warning valve and transmitter does not interfere with the tire ...

Other materials:

Removal
1. PRECAUTION CAUTION: Be sure to read "PRECAUTION" thoroughly before servicing. 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL CAUTION: Wait for 90 seconds after disconnecting the cable to prevent the airbag working. 3. REMOVE INSTRUMENT PANEL FINISH PANEL SUBASSEMBLY LOWER L ...

Initialization
1. RESET When the back door lock is replaced: The power back door ECU cannot receive a switch signal from the lock. This may cause the power back door system to enter fail-safe mode and DTC B2215 to set, and also make the system disabled. When the lock is replaced, be sure to perform t ...

Installation
1. INSTALL TRANSFER ASSEMBLY (a) Apply sealant 1281 to the transaxle assembly and transfer assembly in continuous beaded from of 1.2 mm diameter as shown in the illustration. NOTICE: Wipe any grease off from the attaching surfaces. Install it within 10 minutes after applying the se ...