Toyota Sienna Service Manual: 2Gr-fe charging

Installation

1. INSTALL IGNITION SWITCH ASSEMBLY (a) Install the ignition switch with the 2 screws. (b) Install the ignition switch connector. 2. INSTALL STEERING COLUMN COVER LOWER (a) Attach the 4 claw ...

Charging system

...

Other materials:

Installation
1. INSTALL FRONT SUSPENSION ARM SUBASSEMBLY LOWER NO.1 LH (a) Install the front lower arm bush stopper to the front suspension arm sub-assembly lower No.1 LH. (b) Install the bolt and nut to the rear side of the front suspension arm sub-assembly lower No.1 LH. Torque: 206 N*m (2,100 kgf ...

Reassembly
1. INSTALL UNDERDRIVE PLANETARY RING GEAR HINT: Use a torque wrench with a fulcrum length of 160 mm (6.3 in.). (a) Install a new snap ring to the outer race of the radial ball bearing rear. HINT: When replacing the bearing, also replace the counter driven gear with a new one. (b) Us ...

Check mode procedure
1. CHECK MODE (SIGNAL CHECK): DTC CHECK  Connect the intelligent tester to the DLC3. ) Turn the ignition switch to the ON position. ) Select the "SIGNAL CHECK", and proceed checking using the intelligent tester. NOTICE: Select the "SIGNAL CHECK" from the &q ...