Toyota Sienna Service Manual: Generator

Noise Occurs from Generator while Engine is Running

INSPECTION PROCEDURE 1 CHECK LOOSENESS OF V-RIBBED BELT (a) Check the tension of the belt by pushing it down with a finger. OK: The tension of the belt is enough. 2 CHECK V-RIBBED BELT FOR W ...

Components

...

Other materials:

Unmatched Key Code
DTC B2795 Unmatched Key Code DESCRIPTION This DTC is output when a key with a code that has not been registered in the ECU is inserted into the ignition key cylinder. DTC No. DTC Detection Condition Trouble Area B2795 Key with unregistered key code is i ...

Front wheel alignment
Adjustment NOTICE: For vehicles equipped with VSC, if wheel alignment has been adjusted, and if suspension or underbody components have been removed/installed or replaced, be sure to perform the following initialization procedure in order for the system to function normally: 1. Disconnect the ...

If the vehicle becomes stuck
Carry out the following procedures if the tires spin or the vehicle becomes stuck in mud, dirt, or snow: Stop the engine. Set the parking brake and shift the shift lever to P. Remove the mud, snow, or sand from around the stuck tire. Place wood, stones or some other material under the tires ...