Toyota Sienna Service Manual: 2Gr-fe fuel

Reassembly

1. INSTALL STRAIGHT PIN (a) Using a plastic hammer, tap in new straight pins to the cylinder block. Standard protrusion 2. INSTALL STUD BOLT (a) Using E8 and E10 "TORX" sockets, i ...

Fuel system

...

Other materials:

Reassembly
1. INSTALL 2ND BRAKE PISTON O-RING (a) Coat 2 new O-rings with ATF, and install them in the 2nd brake piston. NOTICE: Make sure that the O-ring is not twisted or pinched. 2. INSTALL 2ND BRAKE PISTON (a) Coat the 2nd brake piston with ATF, and install it to the 2nd brake cylinder. NO ...

Installation
HINT:  Use the same procedures for the RH side and LH side.  The procedures listed below are for the LH side. 1. INSTALL REAR AIRBAG SENSOR LH  Check that the ignition switch is off.  Check that the battery negative (-) terminal is disconnected. CAUTION: ...

Installation
1. INSTALL CENTER AIRBAG SENSOR ASSEMBLY  Check that the ignition switch is off.  Check that the battery negative (-) terminal is disconnected. CAUTION: After disconnecting the negative battery terminal, wait for at least 90 seconds before starting the operation. &n ...