Toyota Sienna Service Manual: Fuel injector

On-vehicle inspection

1. INSPECT FOR FUEL PUMP OPERATION AND FUEL LEAK (a) Check fuel pump operation. (1) Connect the intelligent tester to the DLC3. (2) Turn the engine switch on (IG) and push the intelligent teste ...

Components

...

Other materials:

Disassembly
1. REMOVE NO. 2 FRONT AXLE INBOARD JOINT BOOT LH CLAMP (a) Using pliers, remove the No. 2 front axle inboard joint boot LH clamp, as shown in the illustration. 2. REMOVE FRONT AXLE INBOARD JOINT BOOT LH CLAMP (a) Remove the front axle inboard joint boot LH clamp using the same procedures a ...

Inspection
1. INSPECT MASS AIR FLOW METER  Visually check for any foreign matter on the platinum hot wire (heater) of the mass air flow meter. OK: There is no foreign matter. If the result is not as specified, replace the mass air flow meter. Measure the resistance according to the ...

Disassembly
1. REMOVE REAR SEAT LEG COVER LH  Remove the 2 screws and seat leg cover. 2. REMOVE REAR SEAT LEG COVER RH  Remove the 2 screws and seat leg cover. 3. REMOVE REAR SEAT LEG SIDE COVER LH  Remove the 2 screws and seat leg side cover. 4. REMOVE LH SEAT REAR SEAT LOCK ...