Toyota Sienna Service Manual: Fuel pump

Removal

1. DISCHARGE FUEL SYSTEM PRESSURE HINT: See page FU-1. 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 3. REMOVE NO. 1 ENGINE UNDER COVER 4. DRAIN ENGINE COOLANT (See page CO-6) 5. REMOVE FR ...

Components

...

Other materials:

Communication Error from VSC to ECM
DTC P1630 Communication Error from VSC to ECM DTC U0122 Lost Communication with Vehicle Dynamics Control Module DESCRIPTION The skid control ECU sends signals such as cruise control cancel demand signals and brake operation demand (from ECM) response signals to the ECM when the dynamic laser ...

Precaution
1. INSPECTION PROCEDURE FOR VEHICLE INVOLVED IN ACCIDENT  Perform the zero point calibration and sensitivity check if any of the following conditions occur.  The occupant classification ECU is replaced.  Accessories (seatback tray and seat cover, etc.) are installed. ...

Turn signal light switch
ON-VEHICLE INSPECTION 1. INSPECT TURN SIGNAL FLASHER CIRCUIT  Measure voltage between the terminals as shown in the chart below. Voltage Connect the connector to turn the signal flasher and turn the ignition switch ON, and inspect the wire harness side connector from t ...