Toyota Sienna Service Manual: Air conditioning control assembly

Heater relay (for rear air conditioning system)

ON-VEHICLE INSPECTION 1. INSPECT REAR HEATER RELAY (a) Remove the rear heater relay. (b) Measure the resistance according to the value(s) in the table below. Standard resistance If the re ...

Removal

1. REMOVE AIR CONDITIONING NO.2 CONTROL ASSEMBLY (a) Release the 4 claw fittings and release the air conditioning No. 2 control assembly. (b) Disconnect the connectors and remove the air con ...

Other materials:

Using a flatbed truck
If you use chains or cables to tie down your vehicle, the angles shaded in black must be 45. Do not overly tighten the tie downs or the vehicle may be damaged. WARNINGObserve the following precautions. Failure to do so may result in death or serious injury. When tow ...

Removal
1. REMOVE BACK DOOR CENTER GARNISH Using a clip remover, disengage the 5 clips to remove the back door center garnish. 2. REMOVE REAR SPOILER Disconnect the center stop light connector. Remove the 3 nuts. Using a clip remover, disengage the 2 clips to remove the rear s ...

Fuel Pump Control Circuit
DESCRIPTION The FUEL PUMP relay switches the fuel pump speed according to the engine conditions. The fuel pump operates when the ECM receives the starter-operating signal (STA) and crankshaft-rotating signal (NE). The FUEL PUMP relay is turned ON while the engine is idling or operating at l ...