Toyota Sienna Service Manual: Cooling fan system

Cooling system

On-vehicle inspection 1. INSPECT FOR COOLANT LEAK CAUTION: Do not remove the radiator cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may b ...

Precaution

NOTICE: When the ignition switch is turned off and the engine temperature is high, the cooling fans may operate for approximately 3 minutes. After turning the ignition switch of ...

Other materials:

Diagnosis system
1. CHECK DLC3  The vehicle uses ISO 15765-4 communication protocol. The terminal arrangement of the DLC3 complies with SAE 1962 and matched the ISO 15765-4 format. If the result is not as specified, the DLC3 may have a malfunction. Repair or replace the harness and connecto ...

Removal
HINT: Replace the RH side by the same procedures as the LH side. 1. REMOVE REAR WHEEL 2. REMOVE REAR AXLE SHAFT LH NUT (See page DS- 22) 3. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY LH (a) Removing the 2 bolts, separate the rear disc brake caliper assembly LH. 4. REMOVE REAR DISC 5. SEPARA ...

MPX Body ECU Stop
DTC B1200 MPX Body ECU Stop DESCRIPTION This DTC is detected when communication between the multiplex network body ECU and the multiplex network gateway ECU stops for more than 10 seconds. DTC No. DTC Detection Condition Trouble Area B1200 Body ECU comm ...