Toyota Sienna Service Manual: Disc cannot be Played/ No Playable Files/ Copyright Protection Error

Toyota Sienna Service Manual / Audio / visual / Audio and visual system / Diagnostic trouble code chart / Disc cannot be Played/ No Playable Files/ Copyright Protection Error

DTC 44-7D Disc cannot be Played

DTC 44-7E No Playable Files

DTC 44-7F Copyright Protection Error

DESCRIPTION

DTC No.	DTC Detecting Condition	Trouble Area
44-7D	An incompatible MP3/WMA file is used. Although the file has an extension of ".mp3" or ".wma", the header information cannot be read.	DVD Television display assembly
44-7E	A disc with no music data is used. Playable files are not on the disc (MP3/WMA).
44-7F	A copy-protected file, which cannot be played, is used.

INSPECTION PROCEDURE

HINT: After the inspection is completed, clear the DTCs

1 CHANGE DISC

Insert a disc with a playable file and check if the disc can be played correctly.

HINT: For details on playable files and discs, refer to the Owner's Manual.

OK: The disc can be played correctly.

END

DSP Error

DTC 44-78 DSP Error DESCRIPTION DTC No. DTC Detecting Condition Trouble Area 44-78 An error occurs during the decode process (MP3/ WMA). - IN ...

CD Player Mechanical Error/ CD Insertion and Ejection Error/ CD Reading Abnormal/ CD Changer Mechanical Error/ CD Insertion and Ejection Error/ CD Reading Abnormal

DTC 62-10 CD Player Mechanical Error DTC 62-11 CD Insertion and Ejection Error DTC 62-12 CD Reading Abnormal DTC 63-10 CD Changer Mechanical Error DTC 63-11 CD Insertion and Ejection Error DTC 63 ...

Other materials:

Disassembly
HINT: On the RH side, use the same procedures as on the LH side. 1. REMOVE REAR DOOR WINDOW FRAME MOULDING REAR LH (See page ET-30) 2. REMOVE REAR DOOR WINDOW FRAME MOULDING SUB-ASSEMBLY LH (See page ET-21) 3. REMOVE SLIDE DOOR WINDOW GARNISH LH Fully open the slide door window. Remo ...

Oxygen (A/F) Sensor Pumping Current Circuit
HINT: Although the DTC titles say oxygen sensor, these DTCs relate to the Air-Fuel Ratio (A/F) sensor. Sensor 1 refers to the sensor mounted in front of the Three-Way Catalytic Converter (TWC) and located near the engine assembly. DESCRIPTION Refer to DTC P2195 (See page ES-355 ...

Inspection
1. INSPECT FRONT STABILIZER LINK ASSEMBLY LH (a) As shown in the illustration, flip the ball joint stud back and forth 5 times, before installing the nut. (b) Using a torque wrench, turn the nut continuously at a rate of 2 to 4 seconds per 1 turn and take the torque reading on the 5th turn. ...