Toyota RAV4 manuals

Toyota Sienna Service Manual: Disposal

1. DISPOSE OF SHOCK ABSORBER ASSEMBLY FRONT LH

HINT: Dispose the RH side by the same procedures as the LH side.

(a) Fully extend the shock absorber rod.

(b) Using a drill, make a hole in the cylinder as shown in the illustration to discharge the gas inside.

DISPOSE OF SHOCK ABSORBER ASSEMBLY FRONT LH

CAUTION:
  • When drilling, chips may fly out, work carefully.
  • The gas is colorless, odorless and nonpoisonous.
Installation
1. INSTALL FRONT SHOCK ABSORBER WITH COIL SPRING (a) Install the front shock absorber with coil spring as shown in the illustration. (b) Install the 3 nuts to the upper side of the front shoc ...

Front lower suspension arm
Components ...

Other materials:

Terminals of ECU
1. CHECK POWER SLIDE DOOR ECU LH (WITH POWER SLIDE DOOR) Disconnect the P25 and P26 ECU connectors, and check the voltage and resistance of each terminal of the wire harness side connectors. If the result is not as specified, there may be a malfunction on the wire harness side. ...

Removal
1. REMOVE V-BANK COVER SUB-ASSEMBLY (See page EM-28) 2. DISCONNECT VENTILATION HOSE (a) Disconnect the ventilation hose from the ventilation valve. 3. REMOVE VENTILATION VALVE (a) Remove the ventilation valve. ...

Pressure Control Solenoid "D" Performance (Shift Solenoid Valve SLT)
SYSTEM DESCRIPTION The linear solenoid valve (SLT) controls the transmission line pressure for smooth transmission operation based on signals from the throttle position sensor and the vehicle speed sensor. The ECM adjusts the duty ratio (*) of the SLT solenoid valve to control hydraulic line ...

В© 2011-2026 Copyright www.tsienna.net