Toyota Sienna Service Manual: Distance control ECU

Cruise control main switch

COMPONENTS Removal 1. DISCONNECT BATTERY NEGATIVE TERMINAL 2. REMOVE STEERING WHEEL COVER LOWER NO.2 (24) 3. REMOVE STEERING WHEEL COVER LOWER NO.3 (24) 4. REMOVE HORN BUTTON ASSEMBLY ...

Components

...

Other materials:

Slip Indicator Light does not Come ON
DESCRIPTION The skid control ECU is connected to the combination meter via CAN and multiplex communications. The SLIP indicator blinks during VSC and/or TRAC operation. When the system fails, the SLIP indicator comes on to warn the driver. WIRING DIAGRAM Refer to Slip Indicator Light Rema ...

Catalyst monitor (active air-fuel ratio control type)
(a) Preconditions The monitor will not run unless: The MIL is OFF. (b) Drive Pattern (1) Connect an intelligent tester. (2) Turn the ignition switch to the ON position. (3) Turn the tester or scan tool ON. (4) Clear the DTCs. (5) Start the engine and warm it up. (6) Drive ...

Heated oxygen sensor (for 2wd)
Components Removal 1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL CAUTION: Wait at least 90 seconds after disconnecting the cable from the nagative (-) battery terminal to prevent airbag and seat belt pretensioner activation. 2. REMOVE HEATED OXYGEN SENSOR (for Bank ...