Toyota Sienna Service Manual: Cruise control
- Cruise control system
- Precaution
- System description
- How to proceed with troubleshooting
- Road test
- Problem symptoms table
- Terminals of ECM
- Diagnosis system
- DTC check / clear
- Fail-safe chart
- Data list / active test
- Diagnostic trouble code chart
- Dynamic laser cruise control system
- Precaution
- System description
- How to proceed with troubleshooting
- Road test
- Operation check
- Problem symptoms table
- Terminals of ECU
- Diagnosis system
- DTC check / clear
- Fail-safe chart
- Data list / active test
- Diagnostic trouble code chart
- Cruise control main switch
- Distance control ECU
- Laser sensor
Engine Immobiliser System Malfunction
DTC B2799 Engine Immobiliser System Malfunction
DESCRIPTION
This DTC is output when the ECM detects errors in communication between the
transponder key ECU
and the ECM, or in the communication li ...
Other materials:
Removal
1. REMOVE REAR BUMPER COVER
Put protective tape under the quarter panel.
Partially the fender liner.
HINT:
Do not remove the fender liner completely but
partially so that the bumper cover can be removed.
Remove the 2 screws and 8 clips.
Using a screwdriver, disengage the claws an ...
Removal
1. REMOVE REAR DOOR SCUFF PLATE LH
2. REMOVE REAR DOOR WEATHERSTRIP LH
3. REMOVE BACK DOOR WEATHERSTRIP
4. REMOVE BACK DOOR SCUFF PLATE
5. REMOVE QUARTER TRIM FRONT PANEL ASSEMBLY LH
6. REMOVE VOLTAGE INVERTER ASSEMBLY
Disconnect the connector.
Remove the 2 bolts and the v ...
Removal
1. REMOVE REAR WHEEL
2. REMOVE SKID CONTROL SENSOR WIRE (for 2WD)
(a) Disconnect the skid control sensor connector.
(b) Remove the bolt and disconnect the bracket from
the rear axle beam assembly.
HINT:
Separate the RH side by the same procedures as
the LH side.
3. SEPARATE SPEED SENSO ...
