Toyota RAV4 manuals

Toyota Sienna Service Manual: Error in Picture Circuit/ No Current in Back-light/ Excess Current in Back-light

Toyota Sienna Service Manual / Navigation / Navigation system / Diagnostic trouble code chart / Error in Picture Circuit/ No Current in Back-light/ Excess Current in Back-light

DTC 34-10 Error in Picture Circuit

DTC 34-11 No Current in Back-light

DTC 34-12 Excess Current in Back-light

DESCRIPTION

DTC No.

DTC Detection Condition

Trouble Area

34-10 Error in power supply system for picture circuit Radio and navigation assembly
34-11 Decline in power output from inverter circuit for backlight
34-12 Excess power output from inverter circuit for back-light

INSPECTION PROCEDURE

HINT: After the inspection is completed, clear the DTCs.

1 REPLACE RADIO AND NAVIGATION ASSEMBLY

END

Panel Switch Error/ Touch Switch Error
DTC 21-10 Panel Switch Error DTC 21-11 Touch Switch Error DTC 23-10 Panel Switch Error DTC 23-11 Touch Switch Error DTC 24-10 Panel Switch Error DTC 24-11 To ...

DVD Player Mechanical Error/ DVD Insertion and Ejection Error/ DVD Reading Abnormal
DTC 44-10 DVD Player Mechanical Error DTC 44-11 DVD Insertion and Ejection Error DTC 44-12 DVD Reading Abnormal DESCRIPTION TC No. DTC Detection Condition Trouble Area ...

Other materials:

A/F sensor and ho2s monitors
(a) Preconditions The monitor will not run unless: 2 minutes or more have elapsed since the engine was started. The Engine Coolant Temperature (ECT) is 75°C (167°F) or more. Cumulative driving time at a vehicle speed of 30 mph (48 km/h) or more exceeds 6 minutes. Air-fuel ratio fe ...

Power Slide Door RH does not Operate When Using Inside / Outside Handle
DESCRIPTION  The inside / outside handles have the ability to control operation of the power slide door. Pulling either handle transmits a request signal to the power slide door ECU RH, which then commands the power slide door control motor and clutch to open / close the power sli ...

Installation
1. INSTALL TIRE PRESSURE WARNING VALVE AND TRANSMITTER (a) Insert the tire pressure warning valve and transmitter into the valve installation hole. Insert it from the inside of the rim so that the printed surface can be seen. NOTICE: Check that there is no visible deformation, damage, ...

© 2011-2024 Copyright www.tsienna.net