Toyota Sienna Service Manual: Front passenger airbag assembly

Installation

1. INSTALL SPIRAL CABLE  Check that the front wheels are facing straight ahead.  Set the turn signal switch to the neutral position. NOTICE: If it is not in the neutral pos ...

On-vehicle inspection

1. INSPECT FRONT PASSENGER AIRBAG ASSEMBLY (VEHICLE NOT INVOLVED IN COLLISION)  Perform a diagnostic system check.  With the front passenger airbag assembly installed on the veh ...

Other materials:

MIL Circuit
DESCRIPTION The MIL (Malfunction Indicator Lamp) is used to indicate vehicle malfunctions detected by the ECM. When the ignition switch is turned to the ON position, power is supplied to the MIL circuit, and the ECM provides the circuit ground which illuminates the MIL. The MIL operation ...

Сamshaft timing oil control valve assembly
COMPONENTS ON-VEHICLE INSPECTION 1. INSPECT CAMSHAFT TIMING CONTROL VALVE ASSEMBLY (a) Connect the intelligent tester to the DLC3. (b) Turn the ignition switch to the ON position. (c) Start the engine and warm it up. (d) Select the intelligent tester from the ACTIVE TEST ...

Disassembly
1. REMOVE NO. 1ULTRASONIC SENSOR RETAINER (w/ Clearance Sonar System) (See page PM-19) 2. REMOVE NO. 1 ULTRASONIC SENSOR (w/ Clearance Sonar System) (See page PM-19) 3. REMOVE REAR BUMPER ENERGY ABSORBER 4. REMOVE REAR BUMPER BAR PLATE Remove the 4 clips and the rear bumper bar plate. 5. ...