Toyota Sienna Service Manual: Installation
1. INSTALL FRONT PASSENGER AIRBAG ASSEMBLY
- Install the front passenger airbag assembly with the 2 screws.
2. INSTALL INSTRUMENT PANEL SUB-ASSEMBLY
3. CONNECT FRONT PASSENGER AIRBAG ASSEMBLY CONNECTOR
- Connect the connector to the front passenger airbag assembly.
NOTICE: When handling the airbag connector, take care not to damage the airbag wire harness.
4. INSTALL INSTRUMENT PANEL BOX NO.2
5. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY
6. INSTALL STEERING COLUMN COVER
7. INSTALL STEERING WHEEL ASSEMBLY
8. INSPECT STEERING WHEEL CENTER POINT
9. INSTALL STEERING PAD
10. INSTALL STEERING WHEEL NO.2 COVER LOWER
11. INSTALL STEERING WHEEL NO.3 COVER LOWER
12. PLACE FRONT WHEELS FACING STRAIGHT AHEAD
13. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
14. PERFORM INITIALIZATION
- Perform initialization.
HINT: Some systems need initialization when disconnecting the cable from the negative battery terminal.
15. INSPECT SRS WARNING LIGHT
- Inspect the SRS warning light
Removal
1. PRECAUTION
CAUTION: Be sure to read "PRECAUTION" thoroughly before
servicing.
2. DISCONNECT CABLE FROM NEGATIVE BATTERY
TERMINAL
CAUTION:
Wait for 90 seconds after disconnecting th ...
Disposal
HINT:
When scrapping a vehicle equipped with the SRS or
disposing of the front passenger airbag assembly, be sure to
deploy the airbag first in accordance with the procedure
described below. If an ...
Other materials:
Customize parameters
1. Seat Belt Buzzer ON/OFF Setting
The seat belt buzzer ON/OFF setting, which is a setting
of the buzzer function of the combination meter, can
disable the driver side seat belt buzzer and front
passenger side seat belt buzzer.
NOTICE:
These buzzers should be on for safe driving.
Perform ...
Disposal
HINT:
When scrapping a vehicle equipped with the SRS or
disposing of the front passenger airbag assembly, be sure to
deploy the airbag first in accordance with the procedure
described below. If any abnormality occurs with airbag
deployment, contact the SERVICE DEPT. of the TOYOTA
MOTOR SALES, ...
Park / Neutral Position Switch Circuit
DESCRIPTION
The fold seat control ECU receives signals from the Park/Neutral position
switch and controls the seat
stowing and return operations. If the shift lever is in any position other than
P the seat cannot be operated.
If the ignition switch is in ACC or IG the seat cannot be operate ...
