Toyota Sienna Service Manual: Front seat side airbag assembly

Disposal

HINT:  Use the same procedures for the RH side and LH side.  The procedures listed below are for the LH side.  When scrapping a vehicle equipped with the SRS or disposing of t ...

On-vehicle inspection

1. FRONT SEAT SIDE AIRBAG ASSEMBLY (VEHICLE NOT INVOLVED IN COLLISION)  Perform a diagnostic system check.  With the front seat side airbag assembly installed on the vehicle, pe ...

Other materials:

Stereo Component Amplifier Power Source Circuit
DESCRIPTION This circuit provides power to the stereo component amplifier. WIRING DIAGRAM INSPECTION PROCEDURE 1 INSPECT STEREO COMPONENT AMPLIFIER Disconnect the stereo component amplifier connector.  Measure the resistance according to the value(s) in the table below. S ...

Rear wiper motor and bracket
COMPONENTS REMOVAL 1. REMOVE REAR WIPER ARM  Remove the rear wiper arm head cap from the rear wiper arm.  Remove the nut and the rear wiper arm. 2. REMOVE BACK DOOR GARNISH CENTER 3. REMOVE BACK DOOR SIDE GARNISH LH 4. REMOVE POWER BACK DOOR ROD 5. REMOVE BACK DOOR ...

Installation
1. INSTALL TRANSAXLE HOUSING OIL SEAL (a) Using SST and a hammer, install a new oil seal. SST 09316-60011 (09316-00011) Oil seal installation depth: -0.5 to 0.5 mm (-0.020 to 0.020 in.) (b) Coat the lip of the oil seal with MP grease. 2. INSTALL DIFFERENTIAL SIDE BEARING RETAINER OIL SEA ...