Toyota Sienna Service Manual: Fuel sender gauge assembly
INSPECTION
1. INSPECT FUEL SENDER GAUGE ASSEMBLY
- Disconnect the connector from the fuel sender gauge.
- Check that the float moves smoothly between F and E.
- Measure the resistance between terminals 1 and 2 of the connector according to the value(s) in the table below.
Standard resistance: Fuel sender gauge
HINT: If the value is not as specified, replace the fuel sender gauge assembly.
Installation
1. INSTALL ACCESSORY METER ASSEMBLY
Using torx socket wrench (T10), install the
accessory meter assembly with the 5 screws.
2. INSTALL ROOF CONSOLE BOX ASSEMBLY ...
Engine oil pressure switch
ON-VEHICLE INSPECTION
1. INSPECT ENGINE OIL PRESSURE SWITCH
ASSEMBLY
Disconnect the connector from the oil pressure
switch assembly.
With the switch still installed, measure the
...
Other materials:
Operation check
1. DOOR LOCK FAIL-SAFE
When a malfunction in the door control switch
(manual switch, interlocked with key operation) has
been detected, door lock/unlock operation becomes
disabled.
2. CHECK ELECTRICAL DOOR LOCK OPERATION
Check the basic function.
Check that a ...
Warning Buzzer Malfunction
DTC P1575 Warning Buzzer Malfunction
DESCRIPTION
The ABS & traction actuator (skid control ECU) receives an alarm demand
signal from the ECM and
operates the skid control buzzer. The buzzer sounds to warn that the distance
between the vehicle in front
and your own vehicle is decreasing.
...
Removal
1. REMOVE REAR SEAT LEG SIDE GARNISH SUBASSEMBLY RH
Disengage the clips and remove the seat leg side
garnish sub-assembly RH.
2. REMOVE REAR NO. 2 SEAT ASSEMBLY RH
Remove the bolt and locus cable RH.
Remove the 2 bolts and rear No. 2 seat assembly
RH.
R ...
