Toyota Sienna Service Manual: Engine oil pressure switch
ON-VEHICLE INSPECTION
1. INSPECT ENGINE OIL PRESSURE SWITCH ASSEMBLY
- Disconnect the connector from the oil pressure switch assembly.
- With the switch still installed, measure the resistance between the terminal of the engine oil pressure switch and engine ground.
Standard Resistance:
Engine stopped:
Below 1 Ω
Engine idling:
10 kΩ or higher
HINT: If the value is not as specified, replace the engine oil pressure switch.
Fuel sender gauge
assembly
INSPECTION
1. INSPECT FUEL SENDER GAUGE ASSEMBLY
Disconnect the connector from the fuel sender
gauge.
Check that the float moves smoothly between F and
E.
Measure th ...
Audio / visual
...
Other materials:
Power Source Circuit
DESCRIPTION
Power is supplied to the fold seat control ECU through the L-RR2 SEAT and
R-RR2 SEAT fuses.
WIRING DIAGRAM
INSPECTION PROCEDURE
1 INSPECT FUSE (L-RR2 SEAT, R-RR2 SEAT)
Remove the fuses from the R/B No. 3.
Measure the resistance according to the value(s) in the
...
Installation
1. INSTALL ROOF DRIP SIDE FINISH MOULDING
When exchanging the clips
Remove the tape that remains on the mounting
surface of the vehicle body and then clean the
surface with white gasoline.
Using a heat light, heat up the clip installation
surfaces of the vehicle body and moulding.
...
Disassembly
1. REMOVE MAGNETIC CLUTCH ASSEMBLY
(a) Place the compressor and magnetic clutch in a vise.
(b) Using locking pliers, hold the magnetic clutch hub.
(c) Remove the bolt, magnetic clutch hub, and
magnetic clutch washers.
HINT:
There is no set number of magnetic clutch washers
because the ...
