Toyota Sienna Service Manual: Meter
- Meter / gauge system
- Precaution
- How to proceed with troubleshooting
- Customize parameters
- Problem symptoms table
- Terminals of ECU
- Diagnosis system
- Data list / active test
- On-vehicle inspection
- Combination meter
- Accessory meter
- Fuel sender gauge assembly
- Engine oil pressure switch
Back door lock
INSPECTION
1. INSPECT BACK DOOR LOCK ASSEMBLY (W/O
CLOSER)
Check operation of the door lock.
Using a screwdriver, push the latch in order to
put the back door lock in the ...
Other materials:
Short to B+ in Front Pretensioner Squib LH Circuit
DTC B0138/72 Short to B+ in Front Pretensioner Squib LH Circuit
DESCRIPTION
The front pretensioner squib LH circuit consists of the center airbag sensor
assembly and the front seat
outer belt assembly LH.
This circuit instructs the SRS to deploy when deployment conditions are met.
DTC B01 ...
Mass or Volume Air Flow Circuit/ Mass or Volume Air Flow Circuit Low Input/
Mass or Volume Air Flow Circuit High Input
DESCRIPTION
The Mass Air Flow (MAF) meter is a sensor that measures the amount of air
flowing through the throttle
valve. The ECM uses this information to determine the fuel injection time and to
provide appropriate airfuel
ratio. Inside the MAF meter, there is a heated platinum wire which is ...
Disassembly
1. REMOVE BLOWER ASSEMBLY
(a) Remove the 2 screws and the blower assembly.
2. REMOVE MODE DAMPER SERVO SUB-ASSEMBLY
(a) Remove the 3 screws and the mode damper servo
sub-assembly.
3. REMOVE AIRMIX DAMPER SERVO SUB-ASSEMBLY
(a) Remove the 3 screws and the airmix damper servo
sub-as ...
