Toyota Sienna Service Manual: Horn system

Horn

...

Horn relay

INSPECTION 1. INSPECT HORN RELAY  Remove the horn relay from the instrument panel J/ B.  Measure the horn relay continuity. Standard ...

Other materials:

Installation
1. INSTALL PROPELLER W/CENTER BEARING SHAFT ASSEMBLY (a) Align the matchmarks on the propeller shaft assembly rear flange and differential companion flange, and connect the shaft with the 4 bolts, washers and nuts. (b) Remove SST(s) from the extension housing. (c) Insert the yoke int ...

Short to B+ in Curtain Shield Squib LH Circuit
DTC B1168/86 Short to B+ in Curtain Shield Squib LH Circuit DESCRIPTION The curtain shield squib LH circuit consists of the center airbag sensor assembly and the curtain shield airbag assembly LH. The circuit instructs the SRS to deploy when deployment conditions are met. DTC B1168/86 is ...

Auto Up Operation does not Fully Close Power Window (Jam Protection Function is Activated)
DESCRIPTION If AUTO UP operation does not fully close the power window, the following conditions may be the cause.  The reset of the power window motor has not been completed, resulting in activation of the jam protection function.  The memory of the power window switch misse ...