Toyota Sienna Service Manual: Horn

Indicator Circuit

DESCRIPTION The indicator displays the location of the obstacle and the approximate distance between the vehicle and the obstacle either by blinking or turning on. WIRING DIAGRAM INSPECTION ...

Horn system

PARTS LOCATION PROBLEM SYMPTOMS TABLE HORN SYSTEM ...

Other materials:

Entire Combination Meter does not Operate
DESCRIPTION This is the power source circuit to operate the combination meter assembly. WIRING DIAGRAM INSPECTION PROCEDURE 1 INSPECT COMBINATION METER ASSEMBLY Disconnect the C10 connector. Measure the resistance according to the value(s) in the table below. Standard resistan ...

Disassembly
1. REMOVE REAR NO. 2 SEAT COVER BEZEL  Remove the 5 screws.  Disengage the 5 claws and remove the rear No. 2 seat cover bezel. 2. REMOVE REAR SEAT RECLINING COVER LH  Remove the 2 screws.  Disengage the claw and remove the rear seat reclining cover LH. ...

Reassembly
1. INSTALL CENTER SUPPORT BEARING ASSEMBLY NO.1 (a) Set the center support bearing assembly No. 1 (front) to the intermediate shaft, as shown in the illustration. (b) Install a new washer to the intermediate shaft. NOTICE: Be sure to install the bearing in the correct direction. (c ...