Toyota RAV4 manuals

Toyota Sienna Service Manual: How to proceed with troubleshooting

HINT:

1 VEHICLE BROUGHT TO WORKSHOP

2 CUSTOMER PROBLEM ANALYSIS

3 PROBLEM SYMPTOM CONFIRMATION

Result

Result

SYMPTOM SIMULATION

4 INSPECT BATTERY VOLTAGE

Standard voltage: 11 to 14 V

If the voltage is below 11 V, replace or recharge the battery before proceeding.

5 CHECK COMMUNICATION FUNCTION OF MULTIPLEX COMMUNICATION SYSTEM (BEAN)

  1. Use the intelligent tester to check if the multiplex communication system (MPX) is functioning normally.

Result

Result

6 CHECK COMMUNICATION FUNCTION OF CONTROLLER AREA NETWORK (CAN)

  1. Use the intelligent tester to check for normal function of the CAN communication system.
  2. Check for DTCs.

Result

Result

7 DTC CHECK

Result

Result

8 DTC CHART

9 PROBLEM SYMPTOMS TABLE

10 CIRCUIT INSPECTION

11 TERMINALS OF ECM

12 IDENTIFICATION OF PROBLEM

13 REPAIR OR REPLACE

14 CONFIRMATION TEST

END

System description
1. GENERAL  The dynamic laser cruise control system has two cruise control modes: the constant speed control mode and vehicle-to-vehicle distance control mode.  The vehicle-to- ...

Road test
1. PROBLEM SYMPTOM CONFIRMATION HINT: The dynamic laser cruise control system has two cruise control modes: the constant speed control mode and vehicle-to-vehicle distance control mode.   ...

Other materials:

High Temperature
DTC 62-47 High Temperature DTC 63-47 High Temperature DESCRIPTION DTC No. DTC Detecting Condition Trouble Area 62-47 Sensor detects that CD unit temperature is high. (Over 80C) Radio receiver 63-47 Sensor detects that CD unit temperat ...

How to proceed with troubleshooting
HINT: Use the following procedures to troubleshoot the tire pressure warning system. *: Use the intelligent tester. 1 VEHICLE BROUGHT TO WORKSHOP 2 CUSTOMER PROBLEM ANALYSIS (a) Interview the customer to confirm the trouble. HINT: It is important to collect as much specific informat ...

Fold Lock Switch Circuit
DESCRIPTION Each of the left and right seats has a fold lock switch that detects the lock condition of the seat legs and floor when the seat is in the stowed state. If the fold lock switch detects an unlock condition, the 3rd SEAT indicator on the combination meter will come on. WIRING DIAGR ...

В© 2011-2023 Copyright www.tsienna.net