Toyota Sienna Service Manual: How to proceed with troubleshooting
1 VEHICLE BROUGHT TO WORKSHOP
2 CUSTOMER PROBLEM ANALYSIS
3 CHECK INITIAL CHECK FUNCTION
4 PROBLEM SYMPTOMS TABLE
THE CORRESPONDING SYSTEM DOES NOT EXIST (Go to step 5)
5 BASED ON THE MALFUNCTION SYMPTOM, PERFORM THE TROUBLESHOOTING BELOW
- Operation check (C).
- Terminals of ECU
6 ADJUST, REPAIR OR REPLACE
7 CONFIRMATION TEST
END
System description
1. GENERAL
This system uses ultrasonic sensors to detect any
obstacles at the corners and the rear of the vehicle.
The system then informs the driver of the distance
between the sens ...
Operation check
1. DETECTION RANGE MEASUREMENT AND INDICATOR CHECK
Turn the IG switch ON.
Move the shift lever to the R position (when the back
sonar and rear clearance sonar is checked).
...
Other materials:
Side Airbag Sensor Assembly LH Circuit Malfunction
DTC B1141/33 Side Airbag Sensor Assembly LH Circuit Malfunction
DESCRIPTION
The side airbag sensor LH circuit consists of the center airbag sensor
assembly and side airbag sensor
LH.
If the center airbag sensor assembly receives signals from the side airbag
sensor LH, it judges whether or
...
Gyro Error
DTC 58-10 Gyro Error
DTC 80-10 Gyro Error
DESCRIPTION
DTC No.
DTC Detection Condition
Trouble Area
58-10
Ground short, power supply short, or open circuit in the
gyro signal
Gyro sensor
Radio and navigation assembly
80-10
...
On-vehicle inspection
1. INSPECT CURTAIN SHIELD AIRBAG ASSEMBLY
(VEHICLE NOT INVOLVED IN COLLISION)
Perform a diagnostic system check.
With the curtain shield airbag assembly installed on
the vehicle, perform a visual check. If there are any
defects as mentioned below, replace the front pillar
garn ...
