Toyota Sienna Service Manual: Clearance sonar system
- Precaution
- Parts location
- System description
- How to proceed with troubleshooting
- Operation check
- Problem symptoms table
- Terminals of ECU
- Adjustment
Television camera
COMPONENTS
REMOVAL
1. REMOVE BACK DOOR GARNISH CENTER
HINT:
Back Door:
Power Back Door:
2. REMOVE BACK DOOR SIDE GARNISH LH
HINT:
Back Door:
Pow ...
Precaution
1. NOTES FOR CLEARANCE SONAR SYSTEM
Under the following conditions, the sensor of the
clearance sonar may not operate properly:
Foreign matter such as snow or mud gets on the
...
Other materials:
Stuck in Deceleration Sensor
DESCRIPTION
The yaw rate sensor and deceleration sensor signal is sent to the skid
control ECU through the CAN
communication system. When there is a malfunction in the communication, it will
be detected by the
diagnosis function.
WIRING DIAGRAM
INSPECTION PROCEDURE
HINT:
When ...
Security Horn Circuit
DESCRIPTION
During the alarm sounding state, the relay in the ECU turns on and off in a
cycle of approximately 0.2
seconds, causing the security horn to sound.
WIRING DIAGRAM
INSPECTION PROCEDURE
1 INSPECT SECURITY HORN ASSEMBLY
Disconnect the T1 security horn connector.
C ...
Navigation check mode
HINT:
This mode displays GPS satellite information.
Illustrations may differ from the actual vehicle depending
on the device settings and options. Therefore, some
detailed areas may not be shown exactly the same as on
the actual vehicle.
1. ENTER DIAGNOSTIC MODE ( )
2. NA ...
