Toyota Sienna Service Manual: Park assist / monitoring

Installation

1. INSTALL NAVIGATION ANTENNA ASSEMBLY 2. INSTALL INSTRUMENT PANEL SAFETY PAD SUBASSEMBLY  Using a torque wrench, install the bolt <B>. Torque: 20 N*m (204 kgf*cm, 14 ft.*lbf) ...

Rear view monitor system

PARTS LOCATION SYSTEM DIAGRAM ...

Other materials:

Adjustment
HINT: On the RH side, use the same procedures as on the LH side. Since a centering bolt is used as door hinge mounting bolts on the body side and the door side, the door cannot be adjusted with them on. Substitute a bolt with a washer for the centering bolt. 1. INSPECT BACK DOOR PAN ...

Terminals of ECU
1. CHECK POWER BACK DOOR ECU Disconnect the P13 and P14 ECU connectors, and check the voltage and resistance of each terminal of the wire harness side connectors If the result is not as specified, there may be a malfunction on the wire harness side.  Reconnect the ECU co ...

Removal
HINT:  Use the same procedures for the RH side and LH side.  The procedures listed below are for the LH side. 1. PRECAUTION CAUTION: Be sure to read "PRECAUTION" thoroughly before servicing. 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL CAUTION: Wait for 90 s ...