Toyota Sienna Service Manual: Ignition coil and spark plug

Ignition system

Parts location System diagram ...

On-vehicle inspection

NOTICE: In this section, the terms "cold" and "hot" refer to the temperature of the coils. "Cold" means approximately - 10°C (14°F) to 50°C (122°F). & ...

Other materials:

Removal
1. REMOVE FRONT WHEEL 2. REMOVE FRONT AXLE HUB LH NUT HINT: (See page AH-4) SST 09930-00010 3. SEPARATE SPEED SENSOR FRONT LH HINT: (See page AH-4) 4. SEPARATE FRONT DISC BRAKE CALIPER ASSEMBLY LH HINT: (See page AH-4) 5. REMOVE FRONT DISC 6. SEPARATE TIE ROD ASSEMBLY LH HINT: (See pa ...

Video terminal
COMPONENTS REMOVAL 1. REMOVE REAR DOOR SCUFF PLATE LH 2. REMOVE REAR DOOR WEATHERSTRIP LH 3. REMOVE BACK DOOR WEATHERSTRIP 4. REMOVE BACK DOOR SCUFF PLATE 5. REMOVE QUARTER TRIM FRONT PANEL ASSEMBLY LH 6. REMOVE VIDEO(VIDEO ADAPTER) TERMINAL  Release the 4 claw fittings and ...

Installation
1. INSTALL FRONT DRIVE SHAFT ASSEMBLY LH (a) Coat the spline of the inboard joint shaft assembly with ATF. (b) Align the shaft splines and install the drive shaft assembly with a brass bar and hammer. NOTICE: Set the snap ring with the opening side facing down. Be careful not to d ...