Toyota Sienna Service Manual: Initialization
NOTICE:
- Resetting the power window motor (initializing the pulse sensor) is necessary when the battery terminal is disconnected; when the master switch, wire harness, power window regulator and power window motor are replaced or removed/installed; or when the fuses are replaced. AUTO operation function, jam protection function and remote operation function via the power window master switch do not operate without resetting.
- If the AUTO switch (driver side switch) of the master
switch has been continuously operated for a long
time, the power window motor will stop so that no
additional load can be applied to the motor.
Continuing to operate the switch even after the motor has stopped will cause the switch to blink while restricting the AUTO UP/DOWN function and the remote UP/DOWN function. If this happens, reset the motor again after several minutes have passed.
- Whenever disconnecting the battery terminal, reset all the other systems besides the power window control system.
1. RESET POWER WINDOW REGULATOR MOTOR (DRIVER SIDE)
- Turn the ignition switch ON.
- Halfway open the power window by pressing the power window switch.
- Fully pull up the switch until the power window is fully closed and continue to hold the switch for approx. 1 second after the power window is fully closed.
- Check that the AUTO UP/DOWN function operates
normally.
If the AUTO UP/DOWN function operates normally, reset operations have been completed at this time.
If not normal, follow steps below.
- Disconnect the negative battery terminal for 10 seconds.
- Connect the battery terminal.
- Perform the above steps (a) to (d) again.
HINT: If operation is normal, reset operations have been completed at this time. If not normal, follow steps (4) to (7).
- Turn the ignition switch ON.
- Halfway open the power window by pressing the power window switch.
- Fully pull up the switch until the power window is fully closed and continue to hold the switch for approx. 12 seconds after the power window is fully closed.
- Check that the AUTO UP/DOWN function operates normally.
Customize parameters
HINT:
The following item can be customized.
NOTICE:
After confirming whether the items requested by the
customer are applicable or not for customization,
perform the customize operatio ...
Problem symptoms table
POWER WINDOW CONTROL SYSTEM (W/ JAM PROTECTION)
Symptom
Suspected Area
AUTO UP/DOWN function does not operate
Power window regulator motor assembly (Driver side ...
Other materials:
Noise Occurs
INSPECTION PROCEDURE
1 NOISE CONDITION
Check in which direction the noise comes from (front left
or right, or rear left or right).
Check in which direction the noise comes from.
OK:
The location of the noise source can be
determined
2 CHECK SPEAKERS
Check the installatio ...
Anti-glare function
Manual anti-glare inside rear view mirror
Reflected light from the headlights of vehicles behind can be reduced
by operating the lever.
Normal position
Anti-glare position
Auto anti-glare inside rear view mirror
Responding to the level of brightness of the headlights of veh ...
Front Occupant Classification Sensor RH Collision
Detection
DTC B1786 Front Occupant Classification Sensor RH Collision
Detection
DESCRIPTION
DTC B1786 is output when the occupant classification ECU receives a collision
detection signal sent by
the front occupant classification sensor RH if an accident occurs.
DTC B1786 is also output when the front ...
