Toyota Sienna Service Manual: Windshield / windowglass
- Power window control system (w/ Jam Protection Function)
- How to proceed with troubleshooting
- Operation check
- Customize parameters
- Initialization
- Problem symptoms table
- Diagnosis system
- Data list / active test
- Power window control system (w/o Jam Protection Function)
- Power window master switch
- Front passenger side power window switch
- Rear power window switch
- Power window regulator motor
- Windshield glass
- Rear side window glass
- Back door glass
- Window defogger system
- Window defogger switch
- Windshield deicer relay
- Defogger relay
Installation
1. INSTALL POWER POINT SOCKET ASSEMBLY
Engage the 2 claws to install the power point socket
assembly.
2. INSTALL QUARTER TRIM FRONT PANEL ASSEMBLY
LH
3. INSTALL BACK DOOR SCUFF PL ...
Power window control system (w/ Jam Protection
Function)
PARTS LOCATION
...
Other materials:
Installation
1. INSTALL FRONT DRIVE SHAFT ASSEMBLY LH
(a) Coat the spline of the inboard joint shaft assembly
with ATF.
(b) Align the shaft splines and install the drive shaft
assembly with a brass bar and hammer.
NOTICE:
Set the snap ring with the opening side facing
down.
Be careful not to d ...
SRS Warning Light Remains ON
DESCRIPTION
The SRS warning light is located on the combination meter assembly.
When the SRS is normal, the SRS warning light comes on for approximately 6
seconds after the ignition
switch is turned from the LOCK position to ON position, and then goes off
automatically.
If there is a mal ...
On-vehicle inspection
HINT:
The type of ignition switch on this model differs according to
the specifications of the vehicle. For the expressions used in
this section, refer to the "EXPRESSIONS OF IGNITION
SWITCH" precaution (See page ES-1).
1. CHECK AIR FUEL RATIO COMPENSATION SYSTEM
(a) Connect the inte ...
