Toyota Sienna Service Manual: Input instructions

Toyota Sienna Service Manual / Engine / 2Gr-fe engine control system / Sfi system / Registration / Input instructions

(a) The general VIN input instructions using the intelligent tester are shown below: (b) The arrow buttons (UP, DOWN, RIGHT and LEFT) and numerical buttons (0 to 9) are used to input the VIN.

(d) Alphabetical Character Input

(1) Press the UP and DOWN buttons to select the desired alphabetical character.

(e) Numerical Character Input

(1) Press the numerical button corresponding to the number that you want to input.

HINT:

Numerical characters can be selected by using the UP and DOWN buttons.

(f) Correction

(1) When correcting the input character(s), put the cursor onto the character using the RIGHT and LEFT buttons.

(2) Select or input the correct character using the UP and DOWN buttons, or the numerical buttons.

(g) Finishing Input Operation

(1) Make sure that the input VIN matches the vehicle VIN after input.

(2) Press the ENTER button on the tester.

Registration

NOTICE:The Vehicle Identification Number (VIN) must be input into the replacement ECM. HINT: The VIN is a 17-digit alphanumeric vehicle identification number. The intelligent tes ...

Read vin (vehicle identification number)

(a) The VIN reading process is shown in the flowchart below. Reading the VIN stored in the ECM is necessary when comparing it to the VIN provided with the vehicle. (b) Read the VIN using the int ...

Other materials:

Diagnosis system
1. CHECK DLC3 The ECU uses the ISO 15765-4 for communication protocol. The terminal arrangement of the DLC3 complies with SAE J1962 and matches the ISO 15765-4 format. NOTICE: *: Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not opera ...

Sleep Operation Failure of Occupant Classification ECU
DTC B1796 Sleep Operation Failure of Occupant Classification ECU DESCRIPTION During sleep mode, the occupant classification ECU reads the condition of each sensor while the ignition switch is off. In this mode, if the occupant classification ECU detects an internal malfunction, DTC B1796 ...

A/C ECU Communication Stop
DTC B1262 A/C ECU Communication Stop DESCRIPTION DTC B1262 is output when communication between the A/C amplifier and the multiplex network gateway ECU stops for more than 10 seconds. DTC No. DTC Detection Condition Trouble Area B1262 A/C ECU communicat ...