Toyota Sienna Service Manual: Sfi system
- Precaution
- Definition of terms
- System diagram
- How to proceed with troubleshooting
- Check for intermittent problems
- Basic inspection
- Registration
- Checking monitor status
- Readiness monitor drive pattern
- Problem symptoms table
- Terminals of ecm
- Diagnosis system
- Dtc check / clear
- Freeze frame data
- Check mode procedure
- Data list / active test
- Diagnostic trouble code chart
- Сamshaft timing oil control valve assembly
- Throttle body
- ECM
- Accelerator pedal rod
- Mass air flow meter
- Vvt sensor
Precaution
1. INITIALIZATION
NOTICE:
Perform RESET MEMORY (AT initialization) when
replacing the automatic transaxle assembly, engine
assembly or ECM (See page AX-16).
Perform REGISTRATIO ...
Other materials:
System Too
DESCRIPTION
The fuel trim is related to the feedback compensation value, not to the basic
injection time. The fuel trim
consists of both the short-term and long-term fuel trims.
The short-term fuel trim is fuel compensation that is used to constantly
maintain the air-fuel ratio at
stoich ...
What to do if... (Troubleshooting)
If there is a problem with the hands-free system or a Bluetooth®
device, first check the table below.
When using the hands-free system with a Bluetooth® device
The hands-free system or Bluetooth® device does not
work.
The connected device may not be a compatible Bl ...
Installation
1. INSTALL REAR DIFFERENTIAL SIDE GEAR SHAFT BOLT
(a) Install the bolt tightening the nut through the plate
washer.
2. INSTALL REAR DRIVE SHAFT ASSEMBLY LH
HINT:
(See page DS-26)
3. INSTALL REAR AXLE SHAFT NUT LH
HINT:
(See page DS-26)
4. INSTALL REAR SPEED SENSOR LH
HINT:
(See page D ...
