Toyota Sienna Service Manual: 2Gr-fe engine control system
- Sfi system
- Crankshaft position sensor
- Engine coolant temperature sensor
- Knock sensor
- Efi relay
- Circuit opening relay
- Air fuel ratio sensor relay
- Engine
- Drive belt
- Engine front oil seal
- Engine rear oil seal
- Engine assembly
- Engine unit
Body
GENERAL MAINTENANCE
1. TIGHTEN BOLTS AND NUTS ON CHASSIS AND
BODY
(a) Tighten all the parts of the chassis when necessary.
Steering system
Drive train
Suspension
Brake system
Engine mou ...
Sfi system
...
Other materials:
Removal
HINT:
Use the same procedures for the RH side and LH side.
The procedures listed below are for the LH side.
1. PRECAUTION
CAUTION:
Be sure to read "PRECAUTION" thoroughly before servicing.
2. DISCONNECT CABLE FROM NEGATIVE BATTERY
TERMINAL
CAUTION:
Wait for 90 se ...
Initialization
1. RESET
When the back door lock is replaced:
The power back door ECU cannot receive a switch
signal from the lock. This may cause the power
back door system to enter fail-safe mode and DTC
B2215 to set, and also make the system disabled.
When the lock is replaced, be sure to perform t ...
ON / OFF Indication Parameter Error
DTC 01-E2 ON / OFF Indication Parameter Error
DESCRIPTION
DTC No.
DTC Detection Condition
Trouble Area
01-E2
The signal for ON/OFF control from the master device
has a problem
Radio and navigation assembly
INSPECTION PROCEDURE
HINT:
After the insp ...
