Toyota RAV4 manuals

Toyota Sienna Service Manual: Back door glass

COMPONENTS

COMPONENTS

Installation
1. INSTALL SIDE REAR WINDOW WEATHERSTRIP LH 2. INSTALL QUARTER WINDOW LOCK ASSEMBLY LH 3. INSTALL POWER VENT WINDOW MOTOR ASSEMBLY LH 4. INSTALL SIDE WINDOW ASSEMBLY REAR LH 5. INSTALL RR WINDOW ...

Removal
1. REMOVE BACK DOOR GARNISH CENTER 2. REMOVE BACK DOOR SIDE GARNISH LH 3. REMOVE BACK DOOR SIDE GARNISH RH 4. REMOVE BACK DOOR STRAP COVER 5. REMOVE BACK DOOR PULL STRAP 6. REMOVE BACK DOOR TRIM ...

Other materials:

DTC check / clear
1. CHECK DTC Prepare the intelligent tester. Connect the intelligent tester to DLC3. Turn the ignition switch to the ON position and turn the intelligent tester main switch ON. Use the intelligent tester to check the DTCs, and note them down (For operating instructions, see the int ...

Test mode procedure
1. SPEED SENSOR SIGNAL CHECK (WHEN USING SST CHECK WIRE): HINT: If the ignition switch is turned from the ON to the ACC or LOCK position during Test Mode, the DTCs of the signal check function will be erased. (a) Turn the ignition switch off. (b) Check that the steering wheel is in th ...

Short to GND in Rear Curtain Shield Squib LH Circuit
DTC B1637/85 Short to GND in Rear Curtain Shield Squib LH Circuit DESCRIPTION The rear curtain shield squib LH circuit consists of the center airbag sensor assembly and the curtain shield airbag assembly LH. The circuit instructs the SRS to deploy when deployment conditions are met. DTC ...

В© 2011-2026 Copyright www.tsienna.net