Toyota Sienna Service Manual: Installation
1. INSTALL FRONT SEAT ASSEMBLY RH
- Place the seat assembly in the cabin.
NOTICE: Be careful not to damage the body.
- Connect the connectors under the seat assembly.
- Tighten the 2 bolts on the front side of the seat
assembly.
Torque: 37 N*m (375 kgf*cm, 27 ft.*lbf)
- Tighten the 2 bolts on the rear side of the seat
assembly.
Torque: 37 N*m (375 kgf*cm, 27 ft.*lbf)
- Install the 2 track covers.
2. INSTALL FRONT SEAT HEADREST ASSEMBLY
3. CHECK SRS WARNING LIGHT
4. CHECK SEAT SLIDE ADJUSTER LOCKS
5. INITIALIZE OCCUPANT CLASSIFICATION SYSTEM
Reassembly
1. INSTALL FRONT SEAT CUSHION SHIELD LOWER LH
Install the front seat cushion shield lower LH.
2. INSTALL FRONT SEAT CUSHION SHIELD LOWER
RH
3. INSTALL RECLINING ADJUSTER INSIDE COVER LH ...
Front seat assembly (for Manual Seat)
COMPONENTS
...
Other materials:
How to proceed with
troubleshooting
HINT:
Use the following procedures to troubleshoot the dynamic
laser cruise control system.
*: Use the intelligent tester
1 VEHICLE BROUGHT TO WORKSHOP
2 CUSTOMER PROBLEM ANALYSIS
3 PROBLEM SYMPTOM CONFIRMATION
Result
SYMPTOM SIMULATION
4 INSPECT BATTERY VOLTAGE
Stan ...
System Too Lean/ System Too Rich
DTC P0171 System Too Lean (Bank 1)
DTC P0172 System Too Rich (Bank 1)
DTC P0174 System Too Lean (Bank 2)
DTC P0175 System Too Rich (Bank 2)
DESCRIPTION
The fuel trim is related to the feedback compensation value, not to the basic
injection time. The fuel trim
consists of both the short-term ...
Transmission Range Sensor Circuit Malfunction
(PRNDL Input)
DTC P0705 Transmission Range Sensor Circuit Malfunction
(PRNDL Input)
DESCRIPTION
The park/neutral position switch detects the shift lever position and sends
signals to the ECM.
HINT:
After confirming DTC P0705, use the intelligent tester to confirm the PNP switch
signal in the ALL menu ...
