Toyota Sienna Service Manual: Light control relay
ON-VEHICLE INSPECTION
1. LIGHT CONTROL RELAY
- Inspect relay resistance.
Resistance
Fog light relay
ON-VEHICLE INSPECTION
1. FOG LIGHT RELAY
Inspect relay resistance.
Resistance
...
BRK relay
ON-VEHICLE INSPECTION
1. BRK RELAY
Inspect relay resistance.
Resistance
...
Other materials:
Inspection
1. INSPECT TIRE PRESSURE WARNING RESET SWITCH
(a) Remove the tire pressure warning reset switch.
(b) Measure the resistance between terminals 1 and 2
of the tire pressure warning reset switch when the
tire pressure warning switch is ON and OFF.
Standard resistance
If the result is not as ...
Terminals of ECU
1. CHECK DRIVER SIDE J/B ASSEMBLY (MULTIPLEX NETWORK BODY ECU)
Disconnect the B6, 1C, 1K and 1L J/B connectors.
Measure the voltage and resistance according to
the value(s) in the table below.
HINT:
If the result is not as specified, there may be a
malfunction on the w ...
Installation
1. Install purge vsv
(A) install the purge vsv with the bolt.
Torque: 10 n*m (102 kgf*cm, 7 ft.*Lbf)
(B) connect the 2 vacuum hoses and no. 1 Vacuum
switching valve connector.
2. INSTALL V-BANK COVER SUB-ASSEMBLY (See
page EM-63)
3. CONNECT CABLE TO NEGATIVE BATTERY
TERMINAL ...
