Toyota Sienna Service Manual: Side airbag sensor

Installation

HINT:  Use the same procedures for the RH side and LH side.  The procedures listed below are for the LH side. 1. INSTALL FRONT AIRBAG SENSOR LH  Check that the ignition ...

On-vehicle inspection

1. INSPECT SIDE AIRBAG SENSOR (VEHICLE NOT INVOLVED IN COLLISION)  Perform a diagnostic system check. 2. INSPECT SIDE AIRBAG SENSOR (VEHICLE INVOLVED IN COLLISION AND AIRBAG HAS NOT DEP ...

Other materials:

Problem symptoms table
HINT: Proceed to the troubleshooting for each circuit in the table below. Occupant Classification System Symptom Suspected area The front passenger seat condition differs from the indication by the passenger airbag ON/OFF indicator (DTC is not output). Trouble ...

Terminals of ecu
1. Terminal of ECU (*1): Models with dynamic laser cruise control (*2): 2WD model 2. Terminal Inspection (a) Disconnect the connector and measure the voltage or resistance on the wire harness side. HINT: Voltage cannot be measured with the connector connected to the skid control ECU ...

Drive shaft system
PRECAUTION 1. NOTICE OF REMOVING AND INSTALLING FRONT DRIVE SHAFT ASSEMBLY RH (a) When removing and installing the front drive shaft assembly RH in a 4WD vehicle, be sure to first drain all the transaxle oil and transfer oil. If removal and installation is carried out without draining these oi ...